D-Link Router Models Affected by Remote Code Execution Issue that Will not be Fixed
October 8, 2019
Mo Moin (2461 articles)
Share

D-Link Router Models Affected by Remote Code Execution Issue that Will not be Fixed

Researchers at Fortinet’s FortiGuard Labs have publicly disclosed a critical remote code execution vulnerability affecting some models of D-Link routers.

Security experts at Fortinet’s FortiGuard Labs disclosed a remote code execution vulnerability tracked as CVE-2019-16920. The vulnerability is an unauthenticated command injection issue that was discovered on September 2019. The flaw has received a CVSS v31 base score of 9.8 and a CVSS v20 base score of 10.0.

The bad news for the users is that the vendor will not address it because it affects discontinued products.

According to the Fortinet, the vulnerability impacts D-Link firmware in the DIR-655, DIR-866L, DIR-652, and DHP-1565 router families.

“In September 2019, Fortinet’s FortiGuard Labs discovered and reported an unauthenticated command injection vulnerability (FG-VD-19-117/CVE-2019-16920) in D-Link products that could lead to Remote Code Execution (RCE) upon successful exploitation. We rated this as a critical issue since the vulnerability can be triggered remotely without authentication.” reads the security advisory published by Fortinet.

The vulnerability could be exploited by an attacker sending arbitrary input to a “PingTest” gateway interface to achieve command injection.

“The vulnerability begins with a bad authentication check. To see the problem in action, we start at the admin page and then perform a login action.” continues the advisory. “Here, we implement the POST HTTP Request to “apply_sec.cgi” with the action ping_test. We then perform the command injection in ping_ipaddr. Even if it returns the login page, the action ping_test is still performed – the value of ping_ipaddr will execute the “echo 1234” command in the router server and then send the result back to our server. “

The experts discovered that it is possible to execute code remotely, even without the necessary privileges, due to bad authentication check.
The researchers reported the vulnerability to D-Link on September 22, the vendor the day after acknowledged the issue, but three days later confirmed that no patch will be released because the products are at End of Life (EOL),

Below the disclosure timeline:

22 September, 2019: FortiGuard Labs reported the vulnerability to D-Link.
23 September, 2019: D-Link confirmed the vulnerability
25 September, 2019: D-Link confirmed these products are EOL
3 October 2019: Public disclosure of the issue and released advisory

This post D-Link Router Models Affected by Remote Code Execution Issue that Will not be Fixed originally appeared on Security Affairs.

Read More